Mitsubishi Melsec-A AJ65SBT - 3.2 Performance Specifications

3 - 2 3 - 2
MELSEC-
A
3 SPECIFICATIONS
3.2 Performance Specifications
The following table provides the performance specifications of the AJ65SBT-CLB.
Table
3.2 Performance specifications
Item Specifications
Station type Remote device station
CC-Link Version Ver.1.10
2 stations
64 points each for RX and RY (16 points are used in the system)
8 points each for RWr and RWw
4 stations
128 points each for RX and RY (16 points are used in the system)
16 points each for RWr and RWw
Number of
occupied
stations
8 stations
(4 occupied stations
2
modules)
256 points each for RX and RY (32 points are used in the system)
32 points each for RWr and RWw
AJ65SBT-CLB connection position No restrictions
CC-Link side
External connection system
One-touch connector for communication [transmission circuit] (5-pin,
insulation displacement type connector plug is sold separately)
<Sold separately> Online connector for communication: A6CON-LJ5P
4-point mode 8-point mode 16-point mode
Maximum number of link points
Number in parentheses assumes
use of the same I/O addresses
224 points (448 points)
Control
specifications
Number of link points per station
Number in parentheses assumes
use of the same I/O addresses
4 points
(8 points)
8 points
(16 points)
16 points
(32 points)
Transmission speed 2.5Mbps/625kbps/156kbps
Communication system BITR system (Broadcastpolling Interval Timed Response)
Transmission path format T-branch system
Error control system CRC
Number of connected modules 56 modules
Remote station number 1 to 56
AJ65SBT-CLB connection position Connected at the end of the trunk line
RAS functions
Network diagnostics, internal loopback diagnostics, slave station
separation, automatic return to system
CC-Link/LT side
Communication specifications
Connection cable 1
Dedicated flat cable (0.75mm
2
X4) 4, VCTF cable 3, high
flexible cable
4
Module mounting screw
M4
0.7mm 16mm or more screw
Tightening torque range 78 to 108N
cm
DIN rail can also be used for mounting.
Module mounting direction
Can be mounted in any of six orientations.
(No restrictions on mounting directions)
Voltage 24V DC externally supplied (20.4V DC to 26.4V DC, ripples within 5%)
Current consumption 0.075A (When 24V DC)
24V DC power
supply
2
Start-time current 0.165A (When 24V DC)
Level of protection IP2X
Common
Weight 0.09kg
1 Performance of the CC-Link/LT cannot be guaranteed for use of cables other than the dedicated flat cables, VCTF
cables and high flexible cables.
2 Supplied by the dedicated power supply or power supply adaptor of CC-Link/LT.
3 For VCTF cable specifications, see Table 3.3.
4 Use the dedicated flat cables and high flexible cables accredited by the CC-Link Partner Association. (Refer to Section
2.4.)
3