Mitsubishi Melsec-A AJ65SBT - Facing Direction of the Module Installation

4 - 7 4 - 7
MELSEC-
A
4 PROCEDURE UP TO DATA LINK
Number Name Description
Self-loopback test
setting switch
(CC-Link/LT side)
TST
OFF: Normal operation mode (factory-set)
ON: Self-loopback test mode
Setting Switches
Setting
Value
2 1
Points
0
(factory-set)
OFF OFF 8 points
1 OFF ON 4 points
2 ON OFF 16 points
Point mode setting
switches (CC-Link/LT
side)
MODE
Setting a value other than the above will result in a setting error. (The "L ERR." LED on the
CC-Link/LT side is lit.)
Setting Switches
Setting
Value
2 1
Transmission Speed
0
(factory-set)
OFF OFF 156 kbps
1 OFF ON 625 kbps
2 ON OFF 2.5 Mbps
2)
Transmission speed
setting switches
(CC-Link/LT side)
B RATE
Setting a value other than the above will result in a setting error. (The "L ERR." LED on the
CC-Link/LT side is lit.)
3)
One-touch connector
for communication
A one-touch connector for communication line connection.
Connect two optional one-touch connector plugs for communication to the two connector.
4)
CC-Link/LT Interface
connector
Connector for CC-Link/LT communication line connection.
5) DIN rail hook Used to mount the module to the DIN rail.
6) FG terminal Ground terminal
4.4 Facing Direction of the Module Installation
The AJ65SBT-CLB can be mounted in any of six orientations with a DIN rail or module
mounting screws. (There are no restrictions on the mounting orientations.)
When installing to the side of the board
When installing
on top of the board
When installing
at the bottom of the board