7. PARAMETERS
7 - 51
No./symbol/
name
Setting
digit
Function
Initial
value
[unit]
Control
mode
CP CL
PD24
*DO2
Output device
selection 2
_ _ x x Device selection
Any output device can be assigned to the CN1-23 pin.
Refer to table 7.10 for settings.
0Ch
_ x _ _ For manufacturer setting 0h
x _ _ _ 0h
Table 7.10 Selectable output devices
Setting
value
Output device (Note)
CP CL
_ _ 0 0 Always off Always off
_ _ 0 2 RD RD
_ _ 0 3 ALM ALM
_ _ 0 4 INP INP
_ _ 0 5 MBR MBR
_ _ 0 7 TLC TLC
_ _ 0 8 WNG WNG
_ _ 0 A SA SA
_ _ 0 B Always off Always off
_ _ 0 C ZSP ZSP
_ _ 0 D MTTR MTTR
_ _ 0 F CDPS CDPS
_ _ 1 F CPCC CPCC
_ _ 2 3 CPO CPO
_ _ 2 4 ZP ZP
_ _ 2 5 POT POT
_ _ 2 6 PUS PUS
_ _ 2 7 MEND MEND
_ _ 2 9 CLTS CLTS
_ _ 2 B CLTSM CLTSM
_ _ 2 C PED PED
_ _ 2 D SOUT
_ _ 2 E OUT1
_ _ 2 F OUT2
_ _ 3 0 OUT3
_ _ 3 1 ALMWNG ALMWNG
_ _ 3 3 MSDH MSDH
_ _ 3 4 MSDL MSDL
_ _ 3 7 CAMS CAMS
_ _ 3 8 PT0
_ _ 3 9 PT1
_ _ 3 A PT2
_ _ 3 B PT3
Note. CP: Positioning mode (point table method)
CL: Positioning mode (program method)
The diagonal lines indicate manufacturer settings. Never change the
setting.
PD25
*DO3
Output device
selection 3
_ _ x x Device selection
Any output device can be assigned to the CN1-24 pin.
Refer to table 7.10 in [Pr. PD24] for settings.
04h
_ x _ _ For manufacturer setting 0h
x _ _ _ 0h
To Next Page
Loading...
