10. COMMUNICATION FUNCTION (MITSUBISHI ELECTRIC GENERAL-PURPOSE AC SERVO PROTOCOL)
10 - 27
(g) M code
Reads M code of point tables.
M code will be available in the future.
1) Transmission
Transmits the command [4] [5] + the data No. [0] [1] to [1] [F] corresponding to the point tables to
read. Refer to section 10.1.1.
2) Return
The slave station returns the M code of point table requested.
Data is transferred
in hexadecimal.
Display type
0: Data is used unchanged in hexadecimal.
1: Data must be converted into decimal
Position data writing type
0: Enabled after writing
1: Enabled when power is cycled after writing
00
0
To Next Page
Loading...
