Mitsubishi QJ71BR11 User Manual

5 - 1 5 - 1
MELSEC-Q
5 PARAMETER SETTINGS
5 PARAMETER SETTINGS
There is a needed use GX Developer to set the remote master station CPU module
and each of the parameters in the remote I/O station network module in order to make
the remote I/O network operate.
In setting the parameters, it is possible to make settings from the selection of the type
of MELSECNET/H to the application functions.
The following is a flow chart of the settings.
(1) Parameter settings for the remote master station
Network settings
(1) Starting I/O No.
(2) Network No.
· · · ·
1 to 239
(3) Total stations
· · · ·
Remote master station only
Setting the number of module cards
Network type · · · · MNET/H (Remote master)
Set the following functions
as necessary.
Not required
Required
· · · ·
Section 5.1.1
· · · ·
Section 5.1.2
Common parameters
(1) Transmission range of each station
(LB/LW, LX/LY setting)
Set the following items as necessary.
(2) Reserved station setting
Auxiliary setting
Refresh parameter settings
Setting of valid module during other station access
Writing parameter to CPU module
To cable connection
Routing parameter settings
Interrupt setting parameter settings
1
CPU module reset
· · · ·
Section 5.1.3
· · · ·
Section 5.1.4
· · · ·
Section 5.1.5
· · · ·
Section 7.7
· · · ·
Section 4.6
3
Redundant settings for redundant system
2
· · · ·
Section 5.1.7
1: Refer to the Q-corresponding MELSECNET/H network system reference
manual (PLC to PLC network) for details.
2: Make the settings only when using the redundant system.
3: For the redundant system, write the parameter to the CPU module of the
control system.
5

Mitsubishi QJ71BR11 Specifications

General

Brand	Mitsubishi
Model	QJ71BR11
Category	Controller
Language	English