Mitsubishi QJ71BR11 - Page 303

8 TROUBLESHOOTING
MELSEC-Q
8 - 92 8 - 92
*1 : Characters in parentheses ( ) indicate the special register numbers where individual information is being
stored.
*12: This applies to the CPU module of function version B or later.
*15: This applies to the CPU module with the serial No. of which first 5 digits "04102" or later.
Error
Code
(SD0)
*1
Error Contents and Cause Corrective Action
Corresponding
CPU
3004
The parameter file is incorrect.
Alternatively, the contents of the file
are not parameters.
Check whether the parameter file
version is .QPA, and check the
file contents to be sure they are
parameters.
3006
• The high speed interrupt is set in a
Q02CPU.
• The high speed interrupt is set in a
multiple CPU system.
• The high speed interrupt is set when
a QA1S B or QA B is used.
• No module is installed at the I/O
address designated by the high
speed interrupt.
• Delete the setting of the Q02CPU' s
high speed interrupt. To use high
speed interrupts, change the CPU
module to one of the Q02H/Q06H/
Q12H/Q25HCPU.
• To use a multiple CPU system,
delete the setting of the high-speed
interrupt. To use high speed
interrupts, change the system to a
single CPU system.
• To use either the QA1S B or
QA B, delete the setting of the high
speed interrupt. To use high speed
interrupts, do not use the QA1S B/
QA B.
• Re-examine the I/O address
designated by the high speed
interrupt setting.
Qn(H)
*15
3007
The parameter file in the drive
specified as valid parameter drive by
the DIP switches is inapplicable for the
CPU module.
Create parameters using GX
Developer, and write them to the drive
specified as valid parameter drive by
the DIP switches.
QnPRH
3009
In a multiple CPU system, the modules
for AnS, A, Q2AS and QnA have been
set to multiple control CPUs.
Re-set the parameter I/O assignment
to control them under one CPU
module. (Change the parameters of all
CPUs in the multiple CPU system.)
Qn(H)
*12