Mitsubishi QJ71BR11 - Page 317

8 TROUBLESHOOTING
MELSEC-Q
8 - 106 8 - 106
*1 : Characters in parentheses ( ) indicate the special register numbers where individual information is being
stored.
*12: This applies to the CPU module of function version B or later.
Error
Code
(SD0)
*1
Error Contents and Cause Corrective Action
Corresponding
CPU
3200
The parameter setting is illegal.
• Though Block 0 was set to
"Automatic start" in the SFC setting
of the PLC parameter dialog box,
Block 0 does not exist.
Read the common information of the
error using the peripheral device,
check error step corresponding to its
numerical value (program error
location), and correct the problem.
QnA
Q00J/Q00/
Q01
*12
QnPH
QnPRH
3201 The block parameter setting is illegal.
QnA
Qn(H)
QnPH
QnPRH
3202
The number of step relays specified in
the device setting of the PLC
parameter dialog box is less than that
used in the program.
3203
The execution type of the SFC
program specified in the program
setting of the PLC parameter dialog
box is other than scan execution.
3300
The start I/O number in the intelligent
function module parameter set on
GX Configurator differs from the actual
I/O number.
Check the parameter setting.
QCPU
Rem
3301
The refresh setting of the intelligent
function module exceeded the file
register capacity.
Change the file register file for the one
which allows refresh in the whole
range.
Q00J/Q00/Q01
Qn(H)
*12
QnPH
QnPRH
The intelligent function module's
refresh parameter setting is outside
the available range.
Check the parameter setting.
QCPU
Rem
3302
The intelligent function module's
refresh parameter are abnormal.
Check the parameter setting. QCPU
3303
In a multiple CPU system, the
automatic refresh setting or other
parameter setting was made to the
intelligent function module under
control of another station.
• Delete the automatic refresh setting
or other parameter setting of the
intelligent function module under
control of another CPU.
• Change the setting to the automatic
refresh setting or other parameter
setting of the intelligent function
module under control of the host
CPU.
Q00/Q01
*12
Qn(H)
*12
QnPH