Mitutoyo ID-F125 - CAUTIONS ON USE; Power Supply Warnings; Other Cautions on Use

CAUTIONS ON USE
PowerSupplyWarnings
△
！
WARNING
 External power is supplied to the instrument from an AC power source, through an AC
adapter. Use only the AC adapter specified by Mitutoyo(No.526688A,D,or E/standard
accessory).
 If the instrument is used near a device requiring high voltage, frequency or current, be
sure that this device and the instrument's AC adapter have separate power supplies.
 Use only an AC power supply which conforms to the voltage and frequency written on
the AC adapter. Using a voltage or frequency outside the allowed range may result in
fire or explosion.
 When not using the instrument for an extended period, always unplug the AC adapter
from the power supply to avoid the risk of fire.
OtherCautionsonUse
Observe the following precautions to avoid instrument failure or malfunction.
△
！
CAUTION
 Do not knock, drop or subject the instrument to excessive force.
 Do not disassemble or modify the instrument.
 Do not operate the keys with a pointed instrument (such as a screwdriver).
 Avoid use or storage of the instrument in direct sunlight, or in extremely hot or cold
areas.
 Use of the instrument in areas of low or high atmospheric pressure may cause
instrument failure due to material deterioration.
 Do not store the instrument in a highly damp or dusty environment. Avoid getting water
or oil on the instrument during use.
 Do not use an electric marking or other high voltage device near the instrument.
Electronic parts in the instrument may be damaged. Use in areas where a large amount
of electrical noise is present may result in malfunction.
 Secure the instrument with a dial gage stand or similar fixture in a vibration-free
environment.
 Do not subject the spindle to a vertical load or torsion.
 To clean the instrument, use a dry soft cloth or cotton swab, or one soaked in diluted
neutral detergent. Use of organic solvents (such as thinner or benzene) may result in
failure.
 The spindle may not move smoothly if it becomes dirty. To clean the spindle, wipe it first
with a cloth soaked in alcohol, and then gently with a cloth containing a small amount of
low-viscosity oil.
To maintain measuring accuracy, take note of the following point.
IMPOTANT
 In areas of significant temperature fluctuation, thermal expansion of component
parts may cause the measured origin to shift from the set origin. Use the instrument
in a temperature-controlled room with as little temperature fluctuation as possible.
Before starting measurement, allow the instrument and the item measured sufficient
time to thermally stabilize.
MANUAL No.99MAH001B2
- ii -