3.4.3 Max. Peak Hold Mode
In this mode, the instrument holds the maximum value in the series of varying measured
values.
• Press the [MODE] key twice in the normal mode. "Max" blinks in the display.
• Press the [PRESET/SET] key to switch to Max hold mode ("Max" stops blinking).
• When the spindle moves, the maximum value is held ("H" appears).
• Press the [SET] key to release the hold, display the current position, and start
measuring a new maximum value.
difference of Max,Min,TIR hold mode.
10.00
0.00
5.00
-5.00
a
c
b
d
Path 0
→
a
→
b
→
c
→
d
Max mode 0.00
5.00
10.00
Min mode 0.00
-5.00
TIR mode 0.00
5.00
10.00
15.00
• If max. hold mode is entered from the ABS
system, press the [ZERO/ABS] key for 2 seconds or longer to set the position being
held to zero. The instrument can be used for comparative measurement.
• If max. hold mode is entered from the INC system, press the [ZERO/ABS] key for 2
seconds or longer to set the current position to zero.
difference of after Zero set (at Max. hold mode)
operation
– –
[ZERO/ABS]>2sec [PRESET/SET]
ABS 0.00
H
5.00
H
0.00 -3.00
H
2.00
INC 0.00
H
5.00 0.00 0.00
H
5.00
5.00mm
0.00mm
7.00mm
2.00mm
3.4.4 Min. Peak Hold Mode
In this mode, the instrument holds the minimum value in the series of varying measured
values.
• Press the [MODE] key three times in the normal mode. "Min" blinks in the display.
• Min. hold mode operations are done by the same procedure as max. hold mode.
3.4.5 TIR (Run-Out) Measurement Mode
In this mode, the instrument holds the run-out width in the series of varying measured values.
Only this mode has the same operation in both the ABS and INC systems.
• Press the [MODE] key four times in the normal mode. "TIR" blinks in the display.
• Press the [PRESET/SET] key to set the display to zero ("TIR" appears).
• When the spindle moves, the run-out width is held ("H" appears).
• Press the [SET] key to release the held value and start measuring a new run-out
width value.
MANUAL No.99MAH001B2
9
To Next Page
Loading...
