Mitutoyo ID-F125 - 3 BASIC OPERATIONS

3 BASIC OPERATIONS
Key function list
Key Condition Functions page
ON/OFF Anytime Switching ONOFF 6
Inch, normal mode,
>5sec, (AGD model)
Switching .00005”.0001”( .0005”.001”)
(set preset values and tolerance values are erased.)
6 RES
except above Switching 0.001mm0.01mm(.00005”.0005”) 6
<2sec Switch to the INC system & set to zero 6
Normal or
Tolerance
mode
>2sec Switch to the ABS system 6
While preset Cancel preset value & return to the previous condition. 7
ABS Set to zero at the hold position 9
ZERO
/ABS
Max, Min hold
mode, >2sec
INC Set to zero at the current position 9
Normal mode Enter the origin setting(Switch to the ABS system) 7
While check limit,>2sec Enter the tolerance limit setting 8
PRESET
/SET
except above Enter the selected mode, release the hold 8
Normal mode Select measurement modes 8 MODE
except above,>2sec Return to the normal mode 8
<2sec
Switching the analog display range 10
RANGE/
→Adj.←
>2sec Pointer centering in analog display’s range 10
Normal mode, <2sec Switching the Counting Direction 10 +/–
Any modes, >2sec Switching the function lockunlock 10
in/mm (AGD model) Switching inchmm 6
※ ABS:Absolute measruerment system, INC:Comparative measurement system,
>2sec:Press longger than 2sec., <2sec:Short press(less than 2sec.),
normal ←
↓
[MODE]
<〇> blink
[SET]
→ Upper limit
[SET]>2sec setting
[SET]
→ Lower limit
[SET]>2sec setting
[SET]
→
Tolerance
determination
↓
[MODE]
Max blink
[SET]
→ Max peakhold
[SET]
→
←
release the hold
↓
[MODE]
[MODE]>2sec→
Min
blink
[SET]
→ Min peakhold
[SET]
→
←
release the hold
↓
[MODE]
TIR blink
[SET]
→ TIR
[SET]
→
←
release the hold
➥
[MODE] →
Switch the Measurement modes
MANUAL No.99MAH001B2
-
5
-