Contents
1 NAME OF PARTS ______________________________________________________ 1
1.1 Main Unit _________________________________________________________________ 1
1.2 Ditail of LCD _____________________________________________________________ 2
2 INSTALLING THE INSTRUMENT __________________________________________ 3
2.1 Securing the instrument to a Stand or Fixture _________________________________ 3
2.2 Mounting the Lifting Lever __________________________________________________ 3
2.3 Mounting the Release ______________________________________________________ 3
2.4 Mounting a Lug or Rear Cover _______________________________________________ 4
2.5 Replacing the Contact Point _________________________________________________ 4
3 BASIC OPERATIONS ___________________________________________________ 5
3.1 Connecting the Power Source _______________________________________________ 6
3.2 Starting/ Stopping the instrument ____________________________________________ 6
3.3 Initial Settings_____________________________________________________________ 6
3.3.1 Switching the Inch/ Metric __________________________________________________________ 6
3.3.2 Switching the Resolution___________________________________________________________ 6
3.3.3 Switching the Measurement System__________________________________________________ 6
3.3.4 Setting the ORIGIN (PRESET) ______________________________________________________ 7
3.4 Measurement Modes _______________________________________________________ 8
3.4.1 Normal Mode____________________________________________________________________ 8
3.4.2 Tolerance Mode _________________________________________________________________ 8
3.4.3 Max. Peak Hold Mode_____________________________________________________________ 9
3.4.4 Min. Peak Hold Mode _____________________________________________________________ 9
3.4.5 TIR (Run-Out) Measurement Mode __________________________________________________ 9
3.5 Analog Display ___________________________________________________________ 10
3.5.1 Switching the Display Range_______________________________________________________ 10
3.5.2 Pointer Centering _______________________________________________________________ 10
3.6 Switching the Counting Direction____________________________________________ 10
3.7 Function Lock____________________________________________________________ 10
4 DATA I/O ___________________________________________________________ 11
4.1 Output Connector_________________________________________________________ 11
4.2 Output Data Format _______________________________________________________ 11
4.3 Timing Chart _____________________________________________________________ 12
4.4 Using the Digimatic Presetter _______________________________________________ 12
4.4.1 Setting Limit Values from the Presetter_______________________________________________ 12
5 ERROR MESSAGES & CORRECTIVE MEASURES __________________________ 13
6 SPECIFICATIONS _____________________________________________________ 14
6.1 Specifications of the main unit ______________________________________________ 14
MANUAL No.99MAH001B2 Contents
To Next Page
Loading...
