Configuration Guide
Leviton Dimensions 4000 Series Architectural Lighting Controller
Page 4
OPERATION SETUP QUICK START OVERVIEWCONFIGURATION
Warnings
1: To be installed and/or used in accordance with appropriate
electrical codes and regulations.
2: To be installed by a qualified Electrician.
3: DO NOT CONNECT line voltage wires to low voltage
terminals.
4: For longest lamp life, most lamp manufacturers recommend
their fluorescent lamps should be operated at full
brightness for a minimum or 100 hours before dimming is
permitted.
5: For best results, lamp brands and types should not be
intermixed on a circuit
6: Disconnect power when servicing the dimmer, fixture or
when changing lamps.
7: All devices in the D4000 system are rated for Indoor use
only.
8: TO AVOID FIRE, SHOCK OR DEATH: TURN OFF POWER AT
MAIN CIRCUIT BREAKER OR FUSE AND TEST THAT THE
POWER IS OFF BEFORE WIRING!
9: Test all circuits for any fault before connecting to this
device. Damage to this device due to any fault at the load
or line side is not covered by this products warranty.
10: Know the connected load type
11: DO NOT connect load types for which the device is not
rated
To Next Page
Loading...
Need help?
General