Page 49
Checking Scene Names
You can check for a Scene name without initiating the Scene.
To Check the Scene Name:
Step 1: Press the CLEAR Button
Step 2: Immediately Press the SCENE button you are
interested in.
Step 3: To View another Scene name, Repeat from Step 1.
Using the Optional Remote Control
If you have purchased the optional infrared remote control, you
can use it to operate the Master RAISE/ LOWER, SCENE, MAX
and OFF buttons in the same manner as indicated above. The
maximum range for the remote control is approximately 30 feet,
line of sight. Additional infrared receivers are also available.
Navigating the Menus
To navigate the configuration and setup menus, use the
navigation buttons:
Figure 11 - Programming Buttons
• Left and Right . Moves the cursor back and
forth, or to the previous or next item.
• Up and Down . Scrolls through menus and
submenus; changes selected values.
• Select/Save. Selects a value to be modified; saves the
modified value.
• Menu/Cancel. Enters menu mode; exits submenus; exits
menu mode.
• Clear. Clears or returns a selected value to zero.
Select
Save
Menu
Cancel
Clear
Page
Zones
To Next Page
Loading...
Need help?
General