Mobotix Q26 - Page 5

5
Table of Contents
2.9 Network and Power Connection, Additional Cables 101
2.9.1 Notes on Cable Lengths and Power Supply 101
2.9.2 Connecting the Q26 to the Network Using a Patch Cable 101
2.9.3 Power Supply Using a Switch 102
2.9.4 Power Supply When Connected Directly to a Computer 103
2.9.5 Power Supply with Power-Over-Ethernet Products 103
2.9.6 Connecting a USB Cable 104
2.9.7 Connecting a Two-Wire MxBus Cable 105
2.9.8 Variable PoE 106
3 Operating the Camera 108
3.1 Manual and Automatic Operation – Overview 108
3.2 First Images and the Most Important Settings 110
3.2.1 Manually Setting Up the Network Parameters in a Browser 110
3.2.2 First Images and the Most Important Settings in the Browser 113
3.2.3 First Images and Network Parameter Conguration in MxMC 115
3.2.4 Boot Options of the Camera 118
3.3 Virtual PTZ and Full Image Recording 120
3.3.1 Preparing the Virtual PTZ Function 120
3.3.2 Full Image Recording 122
3.3.3 Special Q26 Conguration in the Browser 124
3.4 MicroSD Card Recording 131
3.4.1 Introduction 131
3.4.2 Formatting the MicroSD Card 133
3.4.3 Activating MicroSD Card Recording 134
3.4.4 Accessing Data on the MicroSD Card 135
3.4.5 Deactivating Card Recording 135
3.4.6 Using a MicroSD Card in a Dierent MOBOTIX Camera 136
3.4.7 Limitations on Warranty When Using Flash Storage Media 136
3.5 CongurationintheBrowser 137
3.5.1 Overview 137
3.5.2 General Browser Settings 139