83
Mounting the Camera with the On-Wall Set
Required Parts
Please check that all components supplied with the In-Ceiling Set are present in the original
packaging rst. The following additional tools are required for installation:
• Power drill with matching hole saw (150 mm diameter) or jigsaw
• MOBOTIX Drilling Templates (available for downloading from www.mobotix.com)
• Scissors to cut out the template
• Pen to mark the hole positions
• Two blue In-Ceiling wrenches from the In-Ceiling Set
• Materials and tools needed to connect the pre-installed MOBOTIX network cable in
the camera with the on-site network cable.
• So cotton cloth to clean the front of the lens
To Next Page
Loading...
