01/02 AWB8230-1413GB
Electrical connection
33
X Remove the screws on terminals R0 and T0 and remove
connector J51.
X Remove the ferrite rings from both cables.
X Push the ferrite rings onto both of the external supply voltage
cables (400 V ~).
X Screw on the cables of the external voltage supply to the
terminals R0 and T0.
Figure 22: Remove the connection of J51 to R0 and T0
Figure 23: Remove the ferrite rings
R0
T0
J51
Figure 24: Push on the ferrite rings
Figure 25: Connecting the external supply voltage
R0
T0
J51
efesotomasyon.com - Klockner Moeller - inverter
To Next Page
Loading...
