Contents
01/02 AWB8230-1413GB
2
4 Operating the DF6 45
Initial startup 45
Keypad 46
Operation with LCD keypad 46
– Menu overview 47
– Changing display and Basic parameters 48
– Changing the parameters of the extended
parameter groups 48
Display after the supply voltage is applied 49
Connection examples 50
– Operation using an external potentiometer 50
– Operation through an analog setpoint value 50
– Operation with fixed frequencies 51
Operational warnings 52
5 Programming the Control Signal Terminals 53
Overview 53
Analog outputs – AM, AMI and FM 57
– Voltage output (AM) 57
– Current output (AMI) 58
– Frequency output (FM) 58
Analog inputs terminals O, O2 and OI 60
– Frequency setpoint definition 60
– Matching of terminals O, O2 and OI 61
– Analog setpoint value matching 62
Programmable digital inputs 1 to 5 65
– Start/stop 67
– Fixed frequency selection (FF1 to FF4) 68
– Bitwise fixed frequency selection (SF1 to SF7) 70
– Analog input changeover (AT) 72
– Second time ramp (2CH) 73
– Controller inhibit and coasting (free run stop – FRS) 74
– External fault message (EXT) 75
– Unattended start protection (USP) 76
– Reset (RST) 77
– Jog mode (JOG ) 78
– PTC/NTC thermistor input, terminal TH 80
– Software protection (SFT) 81
– Motor potentiometer functions: accelerate (UP) –
decelerate (DWN) – reset frequency (UDC) 82
– Use second parameter set (SET) 84
– Activate DC braking (DB) 85
– Change over current limit (OLR) 87
– Heavy mains starting (CS) 88
– Setpoint value through keypad (OPE) 90
– Three-wire control (STA – STP – F/R) 91
– Activate/deactivate PID control Reset PID and
integral component (PIDC) 92
Programmable relay outputs K11 to K34 93
– Signalling relay terminals K11, K12, K14 93
– Relay outputs K23-K24 and K33-K34 94
– Frequency arrival signal (FA1/FA2/FA3) 94
efesotomasyon.com - Klockner Moeller - inverter
To Next Page
Loading...
