21
=
Indicates Glide Is On
(Green LED)
KB MODE TUTORIAL - CREATING A PATTERN (continued)
TURNING GLIDE ON/OFF
To turn Glide ON for a step, simply turn the
GLIDE control to the right. Octave/Location LED
5 is lit green indicating Glide is turned ON for the
current step. To turn Glide OFF for a step, simply
turn the GLIDE control all the way down.
NOTE: Glide rate is not set per-step and is always
determined by the front panel GLIDE control.
ADDING A SLIDE TO STEP 3
To set up a slide, the starting step must be set to maximum Gate Length, or a “Tie” (you already did
this on Step 2).
Now turn Glide ON. Step 3 is the target of the slide in this case.
PATTERN STEP 4
Play any note on the keyboard. Step LED 4 is blinking, and the previous Step LEDs are lit solid.
NOTE: When you enter a note, the Gate Length is updated from the previous step. This is useful if you
are entering a pattern with steps that all have the same Gate Length. In that case you would only need
to set the Gate Length when rst entering a pattern.
PATTERN STEP 5
Do not play a new note.
ENTER A REST FOR STEP 5
Press REST. Step LED 5 is blinking, and the
previous Step LEDs are lit solid. The Octave/
Location LED 8 is also lit green, indicating that
a Rest has been entered on this step.
PATTERN STEP 6
Select a new octave by pressing the LEFT/RIGHT arrows. Now play just one note on the keyboard.
Step LED 6 is blinking and the previous Step LEDs are lit solid.
=
Indicates Rest
(Green LED)
To Next Page
Loading...
