71
ADVICE
4. Cleaning the Basin Unit Component
CAUTION
Clean the items mentioned as described below at least once a day.
>>Otherwise, the equipment could malfunction, its performance could deteriorate,
or lines could become plu
ed.
(1) Inside of Main Tube for Vacuum Syringe and Saliva Ejector
Use the procedure below to clean these tubes after finishing with each patient:
1) Turn main switch on.
2) Take the vacuum syringe and saliva ejector off their holders on the assistant’s side and
suck up one or two cups of water.
Same time, take action while the valve lever in closing situation and open the lever slowly
to vacuum.
3) Return the instruments to their holders.
(2) Cleaning the Cut Filters
CAUTION
Make sure the Filter is properly and firmly in place when you replace after
cleaning.
>>Otherwise the vacuum syringe and saliva ejector will perform poorly, and there is
a risk of malfunctions or plu
ed lines.
Follow the procedure below to clean the cut filter (2 places) at least once a day:
1) Take the cut filter off the unit.
Pick the cap head and then unscrew it slowly.
2) Separate the cap and the cut filter and then clean each with
running water.
3) Put the cut filter and the cap together and then put those ones
back to the unit. Insert the cap firmly and let each knob vertical.
Apply Vaseline to the O-ring at the side of the cap so
that the cap goes in and out smoothly.
Cut Filter
The switch shown length way
To Next Page
Loading...
Need help?
General
