12
2. Foot Control
CAUTION
Please do not assume any dangerous positions when riding on the foot
control, foot pedal or operation levers.
>>Not paying sufficient attention to the above points could result in injury or
damage.
Once the foot control gets wet, do not use the same place again while it is
still wet.
Please restart use after moisture has been wiped off with the main switch
turned off, and after it has dried naturally.
>>Not observing the above could result in injury, damage, electric shock or
other accidents.
Never place a load greater than 10N (1kgf) on the foot control, foot pedal
or operation levers.
>>Doin
so could cause a malfunction or load to abnormal operation.
Please do not place the foot control on an incline or upside down.
>>Doin
so could cause a malfunction or load to abnormal operation.
(1) Manual Chair Operation Levers
1) Operation
Use these levers to raise or lower the backrest and seat.
The chair moves only while one of the levers is actually being
pressed The seat and backrest will stop automatically if they
reach their upper or lower limits. Release the lever when this
happens.
2) Lowest Seat Height
The seat normally goes down to a height of 450mm, but it
can be low- ered to 400mm in the following seat lever
operation.
a) Press the seat lever for the down direction until the seat
automati- cally stops at a height of 450mm.
b) Release the seat lever and then press it again to lower it to
400mm.
The position where the lowering seat stops
automatically depends on the setting of the
R(Reset) switch. (See[5]3.(1) in this manual.)
If the R (Reset) switch is set at the lowest
height, the lowering seat does not stop
automatically on its way to the lowest height.
RAISE
LOWER
UP
DOW
ADVICE
To Next Page
Loading...
Need help?
General
