11
1. Main Switch
CAUTION
Never bump or bang the equipment or expose it to excessive vibration
while the main switch is on.
>> This could cause an accident resultin
in in
ur
or dama
e.
Always turn the main switch off after treatment, during breaks in treatment
or whenever the unit is not in actual use.
>> Otherwise, there could be an accident resultin
in in
ur
or dama
e.
Turn the main switch off before using an electric scalpel in the immediate
vicinity of the equipment. Or, please refrain from using equipment that
causes the electromagnetic waves such as cellular phones.
>> Otherwise, electromagnetic waves emitted by the electric scalpel could cause
the equipment to operate in a random or abnormal way resulting in an
accident causin
in
ur
or dama
e.
(1) Operation
The main switch is located on the lower part of the motor cover.
Turn it on to turn the unit on. The lamp on the side of it lights up
when it is turned on and all the instruments etc. can then be
operated.
Turn it off to turn the unit off. The lamp goes out when it is turned
off.
(2) Save Power Function
For both safety and economy, the unit automatically goes into
the save power mode if it has not been used for the set period
of time. (At shipment setting will be 120 minutes)
>> The operating light goes out. (When equipped with auto
light*)
>> The operating light and its indicator go out.
>> The power for chair operation and the gas burner* is turned
off.
>> The water is turned off.
When in save power mode, normal operation can be restored by
pressing any of the operator’s or assistant’s operation switches,
stepping of the foot pedal or picking up an instrument**.
The save power mode can be turned off. Please contact your
local dealer or the Morita Corp. for the change (60 or 120
minutes).
** : Only corresponded for each circuits with foot control (Air
turbine/Micromotor/Ultrasonic scaler)
Equipment Symbols
* : Option
OFF
ON
Main Switch
(Green lamp lights up
when on.)
Main Switch
(The lamp goes out
during save power
mode.)
ON
OFF