Motion iWMC Series - Chapter 3 Kincoservo+ Software Introduction; Fast Start; Language Configuration; Open and Save Project Files

Moon Control Products Ltd. Tel.: +44 (0)1202 599922 www.mooncontrolproducts.com Page | 9
Chapter 3 KincoServo+ Soware Introducon
This chapter will introduce how to debug and congure servo driver by using KincoServo soware.
Figure 3–1Soware main window
3.1 Fast Start
3.1.1 Language Conguraon
Language can be switched between English and Chinese via menu item Tools->Language.
3.1.2 Open And Save Project Files
Create a new project le via menu item File->New, or by clicking the buon.
Open an exisng project via menu item File->Open, or by clicking the buon and selecng a .kpjt le.
Save a project via menu item File->Save, or by clicking the buon and saving as a .kpjt le.
Note
Saving the project only saves the window in the computer soware, and cannot save the parameters in the
drive.