Motion iWMC Series - Cautions

iWMC Integrated Servo Wheel User Manual
Cauons
Please read and follow the requirements in this manual carefully as it will help you set up and operate the drive
correctly and to opmize its performance. Please be aware of the contents of the warning and strictly follow the
requirements, otherwise dangerous situaons may occur.
Warnings
⚫ Do not install if parts are missing when unboxing or the appearance of the wheel is damaged.
⚫ Please install in a place which is well-venlated, dry and dust-free, no abrasive uid, no oil mist, no iron
powder, no chips, etc., and the surrounding items should be non-ammable.
⚫ When installing/removing the servo wheel, stress must not be applied to the motor body and it must be
ensured that each xing bolt is locked in place.
⚫ Avoid any foreign objects entering the servo wheel. Conducve foreign objects such as screws, metal shavings
or ammable foreign objects entering the servo wheel may cause re and electric shock.
⚫ Do not use gasoline, thinner, alcohol, acidic and alkaline detergents to avoid discoloraon or damage to the
body.
⚫ Before wiring, please make sure that the wheel is isolated for the power source.
⚫ Do not plug and unplug the terminal directly when the power is on.
⚫ Please use the original packaging for storage and transportaon, which provides sucient protecon to avoid
damage during transport.
⚫ Please ensure that this document is available to design engineers, installers, and those responsible for
commissioning machines or systems using this product. Please consider the legal provisions applicable to the
desnaon, and:
—Regulaons and standards
—Provisions for tesng organizaons and insurance companies —Naonal specicaons
⚫ Please ensure that the product is not burdened more than permied during transportaon and storage,
including:
—Mechanical loads
—Impermissible temperature
—Moisture
—Corrosive gas
⚫ Please use the product by following the instrucons and warnings in this document strictly！