ASTRO XTS 5000 Model II 27
General Radio Operation
Receive / Transmit
Radio users who switch from analog to digital radios often assume
that the lack of static on a digital channel is an indication that the
radio is not working properly. This is not the case. Digital technology
quiets the transmission by removing the “noise” from the signal and
allowing only the clear voice or data information to be heard.
This section emphasizes the importance of knowing how to monitor a
channel for traffic before keying up to send a transmission.
Without Using the Volume Set and Monitor Buttons
1 Turn the radio on and select
the desired zone and
channel.
2 Listen for a transmission.
3 Adjust the Volume Control
knob if necessary.
4 Press and hold the PTT
button to transmit. The LED
lights RED while
transmitting.
5 Release the PTT button to
receive (listen).
djust
Level
94C26_XTS5000Mdl2.book Page 27 Friday, June 25, 2010 5:23 PM
To Next Page
Loading...
