Motorola IMPRES 2 - Lithium-ion Battery Preparation for Shipment

If the IMPRES 2 Lithium-Ion battery is equipped with a Sleep mode, the charger puts the battery to sleep
upon completion of Ship Lithium charge.
Prepare only stand-alone Motorola Solutions Lithium-Ion batteries for shipment. Remove the battery from the
radio before placing it into the charger.
Do not store a stand-alone battery in the charger. When preparation for Lithium shipment is complete,
immediately remove the stand-alone battery from the charger. Selection of Lithium shipment supersedes
calibration or reconditioning.
5.3.1
IMPRES 2 Battery
Preparing a Lithium-Ion Battery for Shipment-IMPRES 2 Battery, Must Charge
Table 10: Preparing a Lithium-Ion Battery for Shipment-IMPRES 2 Battery, Must Charge
Status Charger Display LED Indicator
Charger Powers On
IMPRES 2 CHARGER
Green for approximately one
second
Battery Detected
IMPRES 2 BATTERY
Steady Red
Rapid Charging
SHIP LI CHARGE xxx% Rat-
ed Cap
Steady Red
Ship Lithium Complete
LI READY TO SHIP xxx%
Rated Cap
Steady Green
Fault
●
The battery may not be mak-
ing proper electrical contact
with the charger.
● The battery is not an IM-
PRES 2 battery.
● An unknown condition is pre-
venting the battery from be-
ing discharged.
● Charging was completed be-
fore the Ship Lithium goal
could be reached.
● The charger pocket is a spe-
cial type.
WARNING: NOT
CHARGEABLE REMOVE&
REINSERT or WRONG
BATT TYPE CANNOT
SHIP LI or CANNOT
DISCHARGE FOR LI
SHIPMENT or SHIP
INCOMPLETE Low Ca-
pacity:yy% or RADIO
POCKET CANNOT SHIP
LI or CHARGING
POCKET CANNOT SHIP
LI
Blinking Red
MN009418A01-AD
Chapter 5: Charging Procedure
21