Chapter 8
Charger Programming
To upgrade your charger to a newer firmware version, refer to MSI Charger Reprogrammer Installation Guide
(MN005630A01) manual.
8.1
Updating Firmware
Upgrading an IMPRES 2 device or charger to a newer version.
Prerequisites: Remove all inserted batteries from target device or charger.
Procedure:
1. Connect the device or charger to your computer using USB.
The connected device or charger is shown on the main window of the MSI Charger Reprogrammer.
2. Click Check V
ersion to find the latest available version from MSI server.
MN009418A01-AD
Chapter 8: Charger Programming
41
To Next Page
Loading...
