Figure 17: Version V1.11.01 Analyzer Mode Menu
Analyzer Messages for
Pocket #1 on Pocket #1 Display
Back
Press OK to entr
ANALYZER MODE
Press OK to exit
ANALYZER MODE
Analyzer Messages for
Pocket #2 on Pocket #1 Display
Analyzer Messages for
Pocket #nn on Pocket #1 Display
If no keypad button is pressed for 10 minutes, the charger exits Analyzer Mode and returns to normal
message displays.
Pocket #xx is displayed in the upper left corner of the Display
.
To return to Pocket 1 when displaying any other pocket, press OK for more than the Entry Time selection.
7.4
Analyzer Data Menu Selection
This section describes the Analyzer Data Menu selections.
● To sequence through the data as represented, press the right arrow.
● To sequence through the data in reverse order, press the left arrow.
● Press Back → OK to exit from the Analyzer Mode.
● Introduced in V1.11.01, press OK to display the next pocket on the Pocket 1 display.
7.5
Swapping Batteries in a Pocket
If a battery is removed and then the same or a different battery is inserted into the same pocket, the
parameter displayed for the second battery is the same parameter that was being displayed for the first
battery.
The second battery may not have the parameter displayed for the first battery. In this case, the identification
message is displayed for the second battery.
MN009418A01-AD
Chapter 7: Analyzer Mode
36
To Next Page
Loading...
