Name: Motorola LI4278 LINEAR IMAGER
Brand: Motorola
Rating: 4 (1 reviews)

To Next Page

To Previous Page

CHAPTER 5 USER PREFERENCES &

MISCELLANEOUS SCANNER

OPTIONS

Introduction

If desired, program the linear imager scanner to perform various functions, or activate different features. This

chapter describes imaging preference features and provides programming bar codes for selecting these

features.

The linear imager scanner ships with the settings in User Preferences Parameter Defaults on page 5-2 (also

see

Appendix A, STANDARD DEFAULT PARAMETERS for all host device and miscellaneous defaults). If the

default values suit requirements, programming is not necessary.

To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in

non-volatile memory and are preserved even when you power down the linear imager scanner.

If not using a USB cable, select a host type (see each host chapter for specific host information) after the

power-up beeps sound. This is only necessary upon the first power-up when connecting to a new host.

To return all features to default values, scan the Default Parameters on page 5-4. Throughout the programming

bar code menus, asterisks (

*) indicate default values.

NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the

screen, be sure to set the document magnification to a level where you can see the bar code clearly, and

bars and/or spaces are not merging.

Feature/Option

*Indicates Default

*Do Not Suppress Power Up Beeps

(00h)

Option Hex Value for

programming via SSI

command

Motorola LI4278 LINEAR IMAGER Specifications

General