EasyManuals Logo

Motorola LI4278 LINEAR IMAGER Product Reference Guide

Motorola LI4278 LINEAR IMAGER
450 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #119 background imageLoading...
Page #119 background image
USER PREFERENCES & MISCELLANEOUS SCANNER OPTIONS 5 - 19
Decode Session Timeout
Parameter # 88h
This parameter sets the maximum time decode processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
To set a Decode Session Timeout, scan the bar code below. Next, scan two numeric bar codes from Appendix
D, NUMERIC BAR CODES that correspond to the desired on time. Enter a leading zero for single digit
numbers. For example, to set a Decode Session Timeout of 0.5 seconds, scan the bar code below, then scan
the 0 and 5 bar codes. To correct an error or change the selection, scan Cancel on page D-3.
Timeout Between Decodes, Same Symbol
Parameter # 89h
Use this option in presentation mode and Continuous Bar Code Read mode to prevent the beeper from
continuously beeping when a symbol is left in the linear imager scanner's field of view. The bar code must be
out of the field of view for the timeout period before the scanner reads the same consecutive symbol. It is
programmable in 0.1 second increments from 0.0 to 9.9 seconds. The default interval is 0.5 seconds.
To select the timeout between decodes for the same symbol, scan the bar code below, then scan two numeric
bar codes from Appendix D, NUMERIC BAR CODES that correspond to the desired interval, in 0.1 second
increments.
Timeout Between Decodes, Different Symbols
Parameter # 90h
Use this option in presentation mode or Continuous Bar Code Read to control the time the scanner is inactive
between decoding different symbols. It is programmable in 0.1 second increments from 0.1 to 9.9 seconds.
The default is 0.2 seconds.
To select the timeout between decodes for different symbols, scan the bar code below, then scan two numeric
bar codes from Appendix D, NUMERIC BAR CODES that correspond to the desired interval, in 0.1 second
increments.
Decode Session Timeout
Timeout Between Decodes, Same Symbol
NOTE Timeout Between Decodes, Different Symbols cannot be greater than or equal to the Decode Session
Timeout.
Timeout Between Decodes, Different Symbols

Table of Contents

Other manuals for Motorola LI4278 LINEAR IMAGER

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Motorola LI4278 LINEAR IMAGER and is the answer not in the manual?

Motorola LI4278 LINEAR IMAGER Specifications

General IconGeneral
Scan Rate547 scans per second
Decode Capability1D barcodes
Scan PatternSingle line
Light SourceLED
IP RatingIP42
Scanner TypeLinear Imager
BatteryRechargeable Li-ion battery
Drop Specification1.8 m (6 ft) drops to concrete
Operating Temperature14°F to 122°F (-10°C to 50°C)
TechnologyLinear Imager
Radio RangeUp to 100 m (330 ft) in open air
InterfaceUSB, RS232, Keyboard Wedge
Storage Temperature-40°C to 70°C (-40°F to 158°F)
Humidity5% to 95% (non-condensing)
Weight7.9 oz./224 g
Dimensions9.8 cm H x 7 cm W x 18.6 cm L (3.8 in H x 2.7 in W x 7.3 in L)

Related product manuals