Name: Motorola LI4278 LINEAR IMAGER
Brand: Motorola
Rating: 4 (1 reviews)

To Next Page

To Previous Page

CHAPTER 4 RADIO COMMUNICATIONS

Introduction

This chapter provides information about the modes of operation and features available for wireless

communication between linear imager scanners, cradles and hosts. The chapter also includes the parameters

necessary to configure the linear imager scanner.

The linear imager scanner ships with the settings shown in the Radio Communication Default Table on page

4-2 (also see Appendix A, STANDARD DEFAULT PARAMETERS for all host device and miscellaneous linear

imager scanner defaults). If the default values suit requirements, programming is not necessary.

To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in

non-volatile memory and are preserved even when the linear imager scanner is powered down.

If not using a Synapse or USB cable with the cradle, select a host type (see each host chapter for specific host

information) after the power-up beeps sound. This is only necessary upon the first power-up when connected

to a new host.

To return all features to default values, scan a default bar code in Default Parameters on page 5-4. Throughout

the programming bar code menus, default values are indicated with asterisks (

*).

Scanning Sequence Examples

In most cases, scan one bar code to set a specific parameter value.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

*Enable Pair on Contacts

Feature/Option

* Indicates Default

Motorola LI4278 LINEAR IMAGER Specifications

General