GETTING STARTED 1 - 13
Reconditioning the Linear Imager Scanner Battery
To maintain optimal performance of the linear imager scanner NiMH battery, perform a battery recondition
approximately once a year.
To begin the battery recondition cycle:
1. Scan Battery Recondition below.
Battery Recondition
2. Place the linear imager scanner into the cradle.
3. The linear imager scanner must perform two charge cycles to complete the battery reconditioning process
(discharge/charge/discharge/charge). See Table 1-4.
Battery Reconditioning LED Definitions
NOTE If the scanner is removed from the cradle during the battery reconditioning cycle, the scanner exits the
battery reconditioning mode of operation and returns to the normal mode of battery charging (see
Charging the Linear Imager Scanner Battery on page 1-12). To restart the battery reconditioning cycle,
re-scan the Battery Recondition parameter and place the scanner in the cradle.
Table 1-4
Battery Reconditioning LED Definitions
Battery Reconditioning
Mode
LED Comments
Discharging Red Flash Time to discharge is approximately 2.5 hours.
Charging Green Flash Time to charge is typically 3 hours with an external
power supply.
Reconditioning Complete Green - Solid (always on) The linear imager scanner enters a trickle charge until
the linear imager scanner is removed from the cradle.
Note: When the scanner is inserted into the CR0078-S (standard) cradle, the scanner's LED is used as
the charging indicator.
When the scanner is inserted into the CR0078-P (presentation) cradle, the cradle's LED is used
as the charging indicator.
To Next Page
Loading...
Need help?
General
