101
feedback to the person initiating the emergency state via code words,
without drawing undesirable attention.
The factory default is Disabled.
Channel Delay (sec) Use the UP/DOWN arrow keys to select the Emergency Channel Delay
or enter a value directly. The radio must be on a channel for the time
speciļ¬ed here before it can transmit an emergency signal. For
Emergency operation, this delay is sometimes desired to prevent the
radio from sending an emergency signal on an undesired channel
(which may occur while the user is changing channels and pressing
the emergency button). The valid range is 0 (zero) to 7 seconds.
The default is 2 seconds.
Emergency Power Up Use the UP/DOWN arrow keys to enable the Emergency Power Up
feature.
If this feature is enabled, and the user presses the emergency button/
switch when the radio is off, the unit will power up and send an
emergency signal. After sending the emergency signal the radio
remains powered up.
Note: This feature cannot be assigned to control head buttons.
It is only available for the external emergency button or
footswitch.
The factory default is Disabled.
To Next Page
Loading...
Need help?
General