120
DTMF Access/
Deaccess Codes
At the MAIN MENU, press F4, F3, F4 and then F8 to access this screen.
This screen allows the user to define Access/Deaccess Code pairs used
for DTMF phone option. The Access Code is used to keep unauthorized
users from using the interconnect system on the repeater. The
Deaccess Code is used to inform the system about the end of a call and
thus minimize wasted air time. The valid symbols are 0 (zero) through
9, “*”, “#” and “P” (for pause).
Note: These codes can be selected in the Auto Access Code field
on the PHONE OPTIONS screen (F4/F3/F4/F9). Up to 19 code
pairs may be defined.
Press Tab to select the desired field, or press the desired function key
(F1 - F10). If a field is highlighted, enter the Access or Deaccess Code
directly.
Function Key Definitions
F2 - ADD CODE Adds another Access/Deaccess Code pair.
F5 - DELETE CODE Deletes the highlighted Access/Deaccess Code pair from the list. You
will be prompted before the code pair is actually deleted.
DCDH
MOTOROLA Radio Service Software Enter Code.
MCS Model:
MAIN:CHANGE/VIEW:CONFIG:PHONE:CODES
DTMF ACCESS/DEACCESS CODES
--------------------------
Num Access Code Deaccess Code
--- ----------- -------------
1 *1P# *1P#
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
HELP ADD DELETE EXIT
CODE CODE
To Next Page
Loading...
Need help?
General