225
MDC Systems From the MAIN MENU, press F4, F6, F4 and then F3 to access this
screen.
This screen allows you to change or view parameters that pertain to an
MDC system. Press Tab to select the desired field, or press the desired
function key (F1 - F10). If a field is highlighted, use the UP/DOWN
arrow keys to select the desired choice or value.
Function Key Descriptions
F2 - ADD SYS Adds a system.
F3 - PREV SYS Accesses the previous system.
F4 - NEXT SYS Accesses the next system.
F5 - DELETE SYS Deletes the selected MDC system. You will be prompted for
confirmation before the system is actually deleted.
F7 - MORE EMER OPTIONS Brings up a screen where you can configure the MDC Emergency
Feature parameters in addition to the ones located on the MDC
SYSTEMS and MDC SYSTEM OPTIONS screens.
F9 - MORE OPTIONS Allows you to change or view additional MDC system field parameters.
DFDC
MOTOROLA Radio Service Software Use UP/DOWN Arrows to Select Choice.
MCS Model:
MAIN:CHANGE/VIEW:CONV:MDC:SYSTEMS
MDC System.........1
MDC SYSTEMS
-----------
Primary ID...................0001 Emergency.................Enabled
Secondary ID.............00000000 Emergency Type.....Alarm and Call
Variable ID...................000 Emer PTT ID Sidetone.....Enabled
Leading PTT-ID............Enabled Acknowledge Alert Tone...Enabled
PTT-ID Sidetone..........Enabled
Trailing PTT-ID...........Enabled Revert Table
Radio Check...............Enabled
Radio Inhibit.............Enabled Num Zone Channel
Status....................Enabled -----------------
Status Request............Enabled 1 1 1
Message...................Enabled 2 1 1
3 1 1
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
HELP ADD PREV NEXT DELETE MORE EMER MORE EXIT
SYS SYS SYS SYS OPTIONS OPTIONS