77
Clone Radio From the MAIN MENU, press F3 and then F5 to access the TRUNKED
CLONING screen.
The CLONE radio function is used to copy codeplug information from
one radio to another. Only radios with the same model number may be
cloned.
Function Key Descriptions
F2 - READ SER NUM
(Read serial number)
Allows you to read the serial number of the “target” radio.
F3 - CONV ID
(Conventional ID)
Brings up a screen where you can assign MDC IDs. This function will be
active only when a Trunking-capable radio is being cloned.
F4 - LIMITED CLONE Clones the Conventional and radio wide sections of the codeplug. This
deletes the Trunking data and reads the serial number from the radio.
In order to perform Limited Clone:
❒ Trunking system keys (or an FTR Key) are required to clone Trunking
System data.
❒ The target radio must be connected to the computer so that its serial
number can be determined.
F6 - DUPLICATE II/IIi ID Duplicates the selected Type II/IIi ID (the one under the cursor) into
all other Type II/IIi personalities for which system keys are present.
F7 - SAVE FILE Creates or updates an archive copy of the codeplug information on a
disk or hard disk.
Note: An archive copy of every radio installed or serviced is
strongly recommended. You will then be able to quickly restore
customer information in case of a codeplug failure.
F8 - PROGRAM RADIO Programs the “target” radio using saved codeplug data.
CE
MOTOROLA Radio Service Software Select Function F1 - F10.
MCS Model:
MAIN:GET/SAVE/PROG:CLONE RADIO
NEW TRUNKING IDS
Serial Number............ ----------------
System Type I II/IIi
Pers # System Key Type # ID Flt/ATG Indv ID Indv ID
------ ---------- ---- ------ ------- ------- -------
01 Disabled II 01 0001 None 0001
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
HELP READ CONV LIMITED DUPLICATE SAVE PROGRAM EXIT
SER NUM ID CLONE II/IIi ID FILE RADIO
To Next Page
Loading...
Need help?
General