78
Full Cloning System keys for all Trunked Systems in the radio are required to perform a
full clone. Follow the steps below for Full Cloning:
1. Press F2 at the GET/SAVE/PROGRAM MENU to read the radio
codeplug to be cloned. That is the “source” codeplug. An archive
file may also be used as the “source”. A radio and RIB must be
properly connected to the computer and power turned on before you
attempt the READ function.
2. Enter the serial number of the radio to be cloned on the TRUNKED
CLONING screen, or press F2 to read the serial number from the
connected radio. System keys are required to change the serial number.
3. Change the Trunking individual IDs to those required by the new
radio on this screen. If MDC IDs are also used, they can be
changed on the MDC ID screen by pressing F3.
4. Connect the “target” radio to the computer and press F8 to
program the “source” codeplug into the “target” radio. A radio and
a RIB must be properly connected to the computer and the power turned
on before you press F8.
Limited Cloning A limited clone may be performed when all the system keys required
to perform a full clone are not available.
Follow the steps below to perform a limited clone:
1. Press F2 at the GET/SAVE/PROGRAM MENU to read the radio
codeplug to be cloned. That is the “source” codeplug. An archive
file may also be used as the “source”. A radio and RIB must be
properly connected to the computer and power turned on before you
attempt the READ function.
Note: The time required to read a codeplug will vary based on
the processing power of your computer and the size of the
codeplug being read.
2. Press the Limited Clone function key (F4) on the TRUNKED
CLONING screen. At this point all the Trunking data in the “source”
codeplug will be deleted or defaulted. This includes all Trunking
system and Trunking personality data. Zone/Channel,
Conventional, Phone List, Call list and Scan List data will however
be preserved.
!
Caution
When a limited clone is performed, all Trunking
information which existed in the “source” radio will be
deleted or modified to default data. Re-entry of
Trunking information will be required.
!
Caution
Do NOT program this image into the original radio
unless you want all the Trunking data to be deleted.
To Next Page
Loading...
Need help?
General