79
3. Enter the serial number of the radio to be cloned or press F2 to
read the serial number from the connected radio. At this point,
you will have a codeplug image for the “target” radio which
contains Conventional data and Radio wide data from the
“source” radio and no Trunking data. Like any other codeplug file,
this codeplug image may be archived, edited or programmed into
the “target” radio. Normally you will proceed to step 4.
Note: The serial number cannot be read prior to step 2 unless system
keys are present.
4. Program the target radio by pressing F8 from the PROGRAM
RADIO CODEPLUG screen (F3/F8) or the TRUNKED CLONING
screen (F3/F5). A radio and a RIB must be properly connected to the
computer and the power turned on before you attempt this function.
5. Archive the “target” codeplug image.
To Next Page
Loading...
