129
Rx Hold Time (sec) Use the UP/DOWN arrow keys to select the amount of time the radio
remains on a channel after a message has been received before
scanning resumes. Valid entries range from 0 (zero) to 255 seconds in
one-second increments.
The default is 3 seconds.
HUB Suspends Scan This field is used to enable/disable the HUB (Hang Up Box) Suspends
Scan feature.
When enabled, this feature operates as follows:
- If using either a Conventional channel in non-Talkback scan
mode or a Trunking channel in non-Talkback scan mode, scan
operation is suspended while the microphone is removed from the
hang up box. This allows the user to complete a conversation
during this time.
- If using a Conventional channel in Talkback scan mode or a
Trunking Priority Monitor channel in Talkback Scan mode,
standard scan operation is suspended while the microphone is
removed from the hang up box. However, scan will continue to
look at priority members for activity. If activity occurs on priority
members, the radio will scan to the active member and
unmute.
- The Suspend All Scan field will become available to the user.
When enabled, Suspend All Scan enhances the HUB Suspends Scan
operation by suspending ALL scan operation (including scan to
priority members in Conventional or Priority Monitor Talkback
Scan mode).
The factory default is Disabled.
Suspend All Scan This field is used to enable/disable the HUB (Hang Up Box) Suspend All
Scan feature. When enabled, this feature enhances the HUB Suspends
Scan operation. If using a Conventional channel in Talkback scan
mode or Trunking Priority Monitor channel in Talkback scan mode,
ALL scan operation, including scan to priority members, is suspended
while the microphone is removed from the hang up box. This allows
the user to complete a conversation during this time without the
possibility of interruption by scanning to a priority channel.
Note: The setting of HUB Suspend All Scan does not affect the
way the HUB Suspends Scan feature operates for Talkgroup or
Sub-Fleet scan.
The factory default is Disabled.
Carrier Detect Required Use the UP/DOWN arrow keys to enable/disable this feature. When
this option is enabled, the radio will stop scanning and operate on the
priority channels based on carrier squelch detect, but will only
unmute on the standard signalling conditions programmed for that
channel.
The default is Disabled.
To Next Page
Loading...
Need help?
General