139
Field Definitions
Telephone Interconnect Mobile products supported by this RSS support half-duplex phone
communication ONLY. This option allows the radio to initiate and
receive land-to-mobile telephone calls and specifies the type of
interconnect.
ISW Window Adjust Use the UP/DOWN arrow keys to choose a code or enter the code
directly.The ISW Window Adjust value is a timing parameter that is
used to fine-tune Trunking system performance. The valid range of
values is 0 (zero) to FFFF in increments of 1.
The default varies according to radio bandsplit.
Auto Dial Holdoff (ms) Use the UP/DOWN arrow keys to select the amount of time the radio
will wait after gaining access to the phone channel before a pre-
queued phone number will be dialed. It ensures that the fixed end is
ready for dialing to commence. Valid entries range from 0 (zero) to
6375 in the increments of 25 ms.
The default is 2000 ms.
RF Modem If RF Modem is enabled, the radio will be able to function only as an
RF Modem (that is, for use with system watch). When RF Modem is
disabled, the radio operates normally.
The default is Disabled.
Half duplex Implies that communication can take place in one
direction at a time only.
Full duplex Permits communication in both directions
simultaneously.
!
Caution
Do NOT modify this field unless you are a Motorola
Field Technical Representative or unless you understand
Trunking system timing and are absolutely certain that
your modification is correct. Changing the ISW Window
Adjust may actually degrade Trunking system
performance.
To Next Page
Loading...
Need help?
General