9
To install the RSS, follow the steps below:
1. Insert the RSS diskette into drive A.
2. Type A: (press Return).
3. At the A: prompt, type INSTALL.
Note: After installing the RSS on a hard disk, you may notice
new files with CFG or ODB extensions on your hard drive. These
are configuration files used by the system and the RSS. Do NOT
delete or move these files from the C:\MRSS\MCS directory.
RSS Start-Up Procedure After installing the RSS on your hard disk, follow the start-up
procedure below:
1. Log on to the hard drive by typing C: and pressing Return.
2. At the C:\ prompt, type MCS.
This command starts up the RSS. If the software does not start up
correctly, you may hear a tone or see an error message or error code
printed on the display. If this happens, verify that the file MCS.BAT
appears under the root directory of Drive C.