223
RAB 2 Code Type This field will be visible only if the Repeater Access field is set to Enabled and
the Access Type field is set to Manual. Use the UP/DOWN arrow keys to
select the type of Repeater Access Button operation. Depending on your
radio capabilities, choices will be Single Tone, DTMF, MDC or None.
The default is None.
RAB 2 Singletone (Hz)RAB 2
MDC Repeater ID/RAB 1 DTMF
Code
This field will be visible only if the Repeater Access field is set to Enabled,
the Access Type field is set to Manual
For Single Tone and MDC, enter the index from the Single Tone List or
MDC Repeater ID List. Alternatively, the UP/DOWN arrow keys could
be used to scroll through indexes/values. For DTMF, enter the tone
value. Valid DTMF tone values are 0 (zero) through 9, “*” and “#”.
The default is 300 Hz for Single Tone, 0 (zero) Hz for DTMF, and 1 Hz
for MDC.
PTT Code Type This field will be visible only if the Repeater Access field is set to Enabled,
and the Access Type field is set to Auto. Use the UP/DOWN arrow keys to
select the Repeater Access Button operation. Depending on your radio
capabilities, choices will be Single Tone, DTMF or MDC.
The default is Single Tone.
PTT Singletone/PTT MDC
Repeater ID/PTT DTMF Code
This field will be visible only if the Repeater Access field is set to Enabled and
the Access Type field is set to Auto. For Single Tone and MDC, enter the
index into tone table or repeater access ID table. For DTMF, enter the
tone value. DTMF Tone values are 0 (zero) through 9, “*” and “#”.
Alternatively, the UP/DOWN arrow keys could be used to scroll
through indexes/values.
The default is 300 Hz for Single Tone, 0 (zero) Hz for DTMF, and 1 Hz
for MDC.
To Next Page
Loading...
Need help?
General