233
Global Tx Multiplier Use the UP/DOWN arrow keys to enable/disable this feature. Enabling
this feature causes the default Tx Multiplier field value to double. This
effectively doubles how long the transmitter will key after the radio
exhausts all retries without receiving an Ack during Emergency Call. If
this feature is disabled, no doubling of the Tx Multiplier field value will
occur.
The default is Disabled.
Tx Multiplier Use the UP/DOWN arrow keys to choose a value or enter the desired
value directly. This value indicates how long the transmitter will key
after the radio exhausts all retries without receiving an Ack during
Emergency Call. This value is multiplied by the radio's base time. The
valid range of values is 0 (zero) to 3.
The default is 1.
RAC (Repeater Access Code) Allows the user to send a repeater ID to select a repeater either
manually or automatically. Manual repeater acceess (MRAC) requires
the operator to select and send a reepeater access codeword (RAC) prior
to voice transmissions with
Pretime (ms) This is the amount of pretime used before the first MDC Repeater
Access Code (RAC) packet is transmitted. Valid entries are 0 to6350 ms
in steps of 50 ms. The factory default is 200 ms.
Ack Alert Tone If this field is enabled, when a Repeater Access Code (RAC) packet is
transmitted, the repeater will indicate acceptance of the packet by
causing the radio to sound 4 beeps. The factory default is Disabled.
Preambles This is a view only field.
Sidetone If this field is enabled, the radio will generate a sidetone upon
Automatic Repeater Access Code transmission to warn the user not to
talk until the transmission is complete.
To Next Page
Loading...
Need help?
General