18
Setting Default Archive and
Back-up Paths
You can set the drive name and path names for archive files you will
create later. Here’s how to set the default archive and back-up file
paths:
1. Press F9 and then F3 at the MAIN MENU to bring up the
CONFIGURE PATHS AND PORT screen.
2. At the CONFIGURE PATHS AND PORT screen, press Tab as many
times as necessary until the Archive Path field is highlighted. Now
specify the archive file path as follows:
C:\MRSS\MCS\ARCHIVE
3. Type F8 to save the field options displayed on the screen.
Setting a Default COM Port
Use the following steps to specify the serial port to interface with the
radio and RIB. The default port is COM 1.
1. Press F9 and then F3 at the MAIN MENU to bring up the
CONFIGURE PATHS AND PORT screen.
2. Go to the serial port RIB field by pressing Tab five times.
3. Use the arrow keys to scroll through the available field options and
select the appropriate port. Options are COM 1, COM 2, COM 3 or
COM 4.
4. Test the port by pressing F6 COMTEST. If the connections are
okay, you will hear a beep and the words “Communication With
the Radio Was Successful” will appear in the instruction area.
5. Press F8 to save this configuration. The message “Configuration
File Written Successfully” will appear in instruction area of the
screen.
6. Press Esc to exit this screen and go to the MAIN MENU.
Exiting The RSS Before you exit the RSS, always ask yourself these questions:
❒ Did you apply the changes to the radio (that is, save the changes
to the radio)?
❒ Did you apply the changes to a computer file (that is, save
programming to an archive file)?
If you are not at the MAIN MENU, press the Esc key to return to this
menu, and then press F10 followed by F2 to exit to the DOS prompt.
To Next Page
Loading...
Need help?
General