46
Programming Procedure 1. Press F6 to key up the radio. (The radio’s RF output must be
terminated into a 50 ohm load.)
2. Apply the appropriate signal according to instructions in your
Radio Service Manual.
3. While transmitting, modify the Balance Attenuator setting using
the UP/DOWN arrow keys. To increase the adjustment speed, use
the Shift-UP/DOWN arrow keys.
4. A relative Tx power value will be displayed, but you must
determine the actual transmitter power output from the service
monitor.
5. Press F6 to de-key the radio and Tab to move between frequency
points.
6. Press F8 to save the new value.
Function Key Descriptions
F6 - TOGGLE PTT Alternately keys and de-keys the radio being serviced.
F8 - PROGRAM VALUE Programs the selected value into the radio.
Field Definition
New Softpot Value This is the balance value for this frequency. The status bar shows the
relationship between this setting and the minimum and maximum
settings.
To Next Page
Loading...
Need help?
General