69
Function Key Descriptions
F8 - PROGRAM RADIO Programs the selected value into the radio. The RSS will display the
following message: “!!!Warning!!! Continue to program the following
serial number into the CBI radio: <Serial Number>.” Press F2 to proceed
with the initialization and F10 to cancel.
Note: If communication with the radio fails, the RSS will display
a pop-up error message. Check you cable connections and try
again.
Field Definitions
Serial Number Enter the serial number of the radio you wish to initialize. This
number can be found on the outside casing of the radio.
Note: You will NOT be able to initialize the CBI radio unless you
enter a valid serial number.
Model Number This is a read-only field. It displays the model number of the radio
currently attached to the computer using the RIB. The model number
is retrieved from the radio’s controller board and is displayed for
verification purposes only.
FLASHcode This is a read-only field. It displays the FLASHcode of the radio currently
attached to the computer using the RIB. The FLASHcode is retrieved
from the radio’s controller board and is displayed for verification
purposes only.
!
Caution
Once the radio is programmed with the serial number
you provided, you will NOT be able to reprogram the
radio with a different one.
!
Caution
Once the radio is programmed with the serial number
you provided, you will NOT be able to reprogram the
radio with a different one.
To Next Page
Loading...
Need help?
General