1 : Channel Selector Knob
For Analog-only radios, each channel can only be
configured as a conventional analog channel. Use the
Channel Selector Knob to switch between an analog or a
digital channel.
Certain features are unavailable when switching from
digital to analog mode.
Your radio also has features available in both analog and
digital modes. The minor differences in the way each
feature works do not affect the performance of your radio.
A Software License Key sold separately is required to
upgrade analog-only radios to digital radios.
NOTICE:
Your radio also switches between digital and analog
modes during a dual mode scan. See Scan on page
40 for more information.
IP Site Connect
This feature allows your radio to extend conventional
communication beyond the reach of a single site by
connecting to different available sites by using an Internet
Protocol (IP) network.
When the radio moves out of range from one site and into
the range of another, the radio connects to the repeater of
the new site to send or receive calls or data transmissions.
This is done either automatically or manually depending on
your settings.
In an automatic site search, the radio scans through all
available sites when the signal from the current site is weak
or when the radio is unable to detect any signal from the
current site. The radio then locks on to the repeater with
the strongest Received Signal Strength Indicator (RSSI)
value.
In a manual site search, the radio searches for the next site
in the roam list that is currently in range but which may not
have the strongest signal and locks on to the repeater.
English
18 Send Feedback
To Next Page
Loading...