NOTICE:
If your radio is set to Silent with Voice, it
will not display any audio or visual indicators
during Emergency mode when you are
making the call with hot mic, but allow sound
through the speaker when the target radio
responds after the programmed hot mic
transmission period is over.
The indicators will only appear when you
press the PTT button.
Exiting Emergency Mode After Sending
the Emergency Alarm
This feature is only applicable to the radio sending the
Emergency Alarm.
Your radio exits Emergency mode when:
• An acknowledgment is received (for Emergency Alarm
only).
• An Emergency Exit Telegram is received.
• All retries to send the alarm have been exhausted.
•
The Emergency Off button is pressed.
• Turn the radio off and then power it on again if your
radio has been programmed to remain on the
Emergency Revert channel even after
acknowledgement is received.
NOTICE:
If your radio is powered off, it exits the Emergency
mode. The radio does not reinitiate the Emergency
mode automatically when it is turned on again.
Receiving Emergency Alarms
Follow the procedure to receive Emergency Alarms on your
radio.
When you receive an Emergency Alarm:
• A tone sounds.
•
The red LED blinks.
You can silence the tone. Do one of the following:
• Press the PTT button to call the group of radios which
received the Emergency Alarm.
• Press any programmable button.
• Exit Emergency mode.
English
Send Feedback 47
To Next Page
Loading...