Figure 1: Battery Eliminator Overview
Table 11: Battery Eliminator Overview
No. Description
1 UART Communication Mode
2 USB/Normal Power ON Mode
3 Blank Board Flashing Mode
4 UART Connector
CAUTION: Connect the red (+) and black (-) wires of the battery eliminator to the respective
positive and negative points of the power supply, and use the correct voltage (3.8 VDC,
maximum 4.2 VDC). Failing to properly connect the wires would damage your radio and/or the
power supply.
MN002952A01-AH
Chapter 4: Test Setup and Testing
33
To Next Page
Loading...
