4.2.1
Connecting the Radio in Blank Flash Mode
The function of this mode is for blank board flashing.
Procedure:
1 Flip up the battery eliminator switch.
2 Connect the serial data cable to the PC.
3 To enter Boot Me mode, press the On/OFF button or connect the programming cable to the PC.
Figure 7: Connecting the Radio in Blank Flash Mode (1 of 2)
No. Description
1 Personal Computer
2 Power Supply 3.8 V
3 Serial Data Cable
4 Programming Cable (USB Type-C)
4 Push the battery eliminator switch to the middle.
5 Ensure that the programming cable is connected to the radio and the PC.
6 Flash the software or firmware to the radio.
MN002952A01-AH
Chapter 4: Test Setup and Testing
39
To Next Page
Loading...
