Motorola ST7000 - Testing Charger Recognition

37 The display shows:
Bluetooth
Test
38 Do the following:
Action Result
Press any key. The display shows:
BT test - pairing
WAIT !!!
NOTICE: Be prepared with supported Bluetooth
accessories configured to pairing mode.
Wait for result. The display shows pairing test result.
Press any key to continue. The display shows pairing connection test result.
Press any key to continue. The display shows:
BT microphone
test - start
Speak into the internal mi-
crophone.
You hear yourself in the paired Bluetooth audio speaker.
Press any key to continue. The display shows:
BT speaker
test - start
Speak into the paired
Bluetooth microphone.
You hear yourself in the internal speaker.
39 Press the corresponding key to proceed to the next test.
Tx Power Test
40 The display shows:
TX Power Class 3L test
41 Press the corresponding key to continue.
42 The display shows:
TX Power Class 4 test
43 Press the corresponding key to continue.
The display shows:
End Test
Press any key
to turn the
radio OFF
Test is completed. Press any key to turn the radio OFF.
4.13.2
Testing Charger Recognition
Procedure:
1 Turn the radio ON.
2 Connect the Rapid Travel Charger accessory connector to the handset. Check the following:
• LCD display shows charger connected.
MN002952A01-AH
Chapter 4: Test Setup and Testing
60